SS Bend CNC Thread 3"

It is used to change the direction of compatible threaded pipework in irrigation and water-delivery installations.

Select the bend according to the nominal thread size of the mating pipe or fitting. Always confirm thread compatibility before installation.

Clean the mating threads, apply a suitable thread-sealing method where required, start the connection by hand to avoid cross-threading, and tighten carefully with an appropriate tool.

No. Excessive tightening can damage the threads or connected components. Tighten only enough to achieve the required assembly.

Suitability depends on the pressure rating of the complete installed system, mating components and operating conditions. Do not assume a pressure rating unless one is specified.

It may be removed and reinstalled when the fitting and threads remain undamaged. Inspect the threads and renew the thread seal as appropriate before reassembly.

Periodically inspect the threaded connection for leakage, movement or visible damage. Replace the fitting if the threads are damaged or the fitting is deformed.

Every price on this site is MRP, inclusive of tax. It is the same for everyone — there is no separate dealer login or hidden rate. For bulk quantities, send a bulk enquiry and we will quote on volume.

Micro-irrigation equipment — drip and sprinkler systems — attracts 5% GST under Indian tax rules. General plastic pipe and fittings attract 18%. The rate that applies is shown on each product page rather than assumed.

No. Small drip fittings such as joiners and end caps arrive boxed — 100 to a bag, for instance — but you order in pieces and can buy a single one. The box quantity and its price are shown alongside the per-piece MRP so you can see both, and any product with a genuine minimum order states it on its page and on its data sheet.