Inline flat drip pipe Ultraflow series 16 MM-0.4 MM

Yes. Appropriate filtration is recommended for drip irrigation systems to reduce the risk of emitter blockage. Select the filtration level according to the water source, water quality and emitter requirements.

It is designed for compatible drip irrigation systems where controlled water application is required along crop rows.

he specified operating pressure is 1 to 3.5 kg/cm². The system should be operated within this range.

Connect it to a compatible take-off from the submain, remove twists and kinks, flush the lateral before closing the end, and gradually pressurize the system.

Position the emitter outlets according to the installation orientation recommended for the particular drip system. Keep the lateral free from twists and sharp bends.

Yes, but the practical lateral length depends on available pressure, field conditions, elevation changes, required discharge uniformity and the overall system design.

Use appropriate filtration, flush the laterals periodically and maintain clean water passages. The required maintenance frequency depends on water quality and operating conditions.

Reuse depends on the condition of the pipe after removal. Inspect for cuts, cracks, blocked emitters, stretched sections and damaged connections before reuse.

Flush and drain it, allow it to dry where practical, roll it without sharp bends or excessive compression, and store it away from direct sunlight, heat and physical damage.

Check filtration, flushing, pressure at the lateral inlet, kinks or blockage. If the problem persists, inspect the affected section and emitters.

Do not extend it solely based on the physical coil length. Lateral length should be determined by the available pressure, required discharge uniformity and complete irrigation-system design.

Every price on this site is MRP, inclusive of tax. It is the same for everyone — there is no separate dealer login or hidden rate. For bulk quantities, send a bulk enquiry and we will quote on volume.

Micro-irrigation equipment — drip and sprinkler systems — attracts 5% GST under Indian tax rules. General plastic pipe and fittings attract 18%. The rate that applies is shown on each product page rather than assumed.

No. Small drip fittings such as joiners and end caps arrive boxed — 100 to a bag, for instance — but you order in pieces and can buy a single one. The box quantity and its price are shown alongside the per-piece MRP so you can see both, and any product with a genuine minimum order states it on its page and on its data sheet.