Inline flat drip pipe Aquaflow series 16 MM-0.2 MM

It is designed for compatible drip irrigation systems where controlled water application is required along crop rows.

The specified operating pressure is 1 to 1.5 kg/cm². The system should be operated within this range.

Appropriate filtration is recommended to reduce the risk of emitter blockage. The filtration level should be selected according to the water source, water quality and emitter requirements.

Lay the lateral along the planned crop row, remove twists and kinks, connect it to a compatible take-off and flush the lateral before closing the downstream end.

Keep the downstream end open and flush the line until the discharged water is reasonably clear. Close the end only after flushing is complete.

Select the length according to the irrigation-system design, available inlet pressure, terrain and required water-distribution uniformity rather than simply using the full coil length.

Use appropriate filtration and periodic flushing, and maintain the irrigation system according to the water quality and operating conditions.

Reuse depends on its condition after removal. Inspect for cuts, cracks, blocked emitters, stretched sections and damaged connections before reuse.

Flush and drain it, allow it to dry where practical, roll it without sharp bends or excessive compression, and store it away from direct sunlight, excessive heat and physical damage.

Check inlet pressure, filtration, flushing, kinks, blocked emitters and the condition of the lateral. Also check whether the lateral length is appropriate for the available pressure.

Yes, compatible water-soluble fertilisers can be applied through a properly designed drip fertigation system. Fertilisers should be completely dissolved and suitable for drip irrigation.

Every price on this site is MRP, inclusive of tax. It is the same for everyone — there is no separate dealer login or hidden rate. For bulk quantities, send a bulk enquiry and we will quote on volume.

Micro-irrigation equipment — drip and sprinkler systems — attracts 5% GST under Indian tax rules. General plastic pipe and fittings attract 18%. The rate that applies is shown on each product page rather than assumed.

No. Small drip fittings such as joiners and end caps arrive boxed — 100 to a bag, for instance — but you order in pieces and can buy a single one. The box quantity and its price are shown alongside the per-piece MRP so you can see both, and any product with a genuine minimum order states it on its page and on its data sheet.